Water Heater Repair in Scottsdale, AZ
Water heaters fail in two ways: they stop heating, or they start leaking. The second one can't wait. Scottsdale's hard water makes both a little more likely.
If it's leaking
- Smell gas? Stop. Leave the house and call 911 and Southwest Gas at 877-860-6020 from outside (Southwest Gas). Don't touch the heater's controls or the garage door opener.
- Close the cold-water valve on the pipe going into the top of the heater. If you can't find it or it won't turn, shut off the whole house.
- Cut the heat. Electric: switch off the heater's breaker. Gas: turn the control knob to "pilot" or "vacation".
- Work out where the water comes from. A drip at a pipe fitting or valve on top is often a small repair. Water from the pipe on the side (the relief valve line) means the heater is letting off pressure or heat: call a plumber now, and keep clear of hot water coming from that pipe. Water from under the tank itself usually means the tank is done.
If there's no hot water
For an electric heater, check whether its breaker has tripped. Reset it once; if it trips again, leave it off and call a plumber. For a gas heater, the pilot may have gone out. A pilot that won't stay lit is a job for a plumber. If you smell gas at any point, leave the house and call 911 and Southwest Gas at 877-860-6020.
Why Scottsdale heaters scale up
The city measures its water at 16 to 25 grains per gallon of hardness, depending on area, with the hardest water south of Indian School Road (fact sheet). Heat drives those minerals out as scale, which settles in the bottom of a tank heater. The city says scale reduces the efficiency of some appliances, and it recommends setting water heaters to 120 to 125°F. A rumbling or popping tank is usually scale.
Repair or replace?
National prices give a sense of the stakes:
| Job | Typical price |
|---|---|
| Water heater repair | $150 to $1,200 (Fixr) |
| Gas tank heater replaced | about $1,900 on average; most pay $1,000 to $2,700 (Fixr) |
| Electric tank heater replaced | $800 to $1,500, about $1,000 on average (Fixr) |
| Tankless heater installed | about $2,811 on average; $2,500 to $4,500 (Fixr) |
A leaking tank is a replacement. A failed thermostat, element, igniter or valve is usually a repair. If the heater is old and the repair quote is a large share of a new one, ask for both prices.
Replacing it in Scottsdale: the permit
Scottsdale lists gas or electric water heater replacement as a Minimum Plumbing Permit item (city page). Because a permit is required, Arizona law requires the installer to hold a contractor license, however small the bill (Registrar of Contractors). Ask whether the quote includes the permit, hauling away the old tank and any changes needed to bring the installation up to current code.
Questions to ask
- Same size and fuel, or are you recommending a change? Why?
- Is the permit included? Who books the inspection?
- What's the warranty on the heater, and on your labor, in writing?
- What's your ROC license number? (How to check it.)
Related pages
- Emergency plumber in ScottsdaleThe first ten minutes, numbers and costs
- Hard water in ScottsdaleHardness by area and what it does to pipes
- What an emergency plumber costsTrip fees, after-hours rates, common jobs
- Check an Arizona licenseWhen a license is required and how to look one up
Sources
- Southwest Gas: natural gas safety information (PDF)
- Scottsdale Water: hard water fact sheet (PDF)
- Fixr: emergency plumbing costs (Oct 31, 2026)
- Fixr: gas water heater cost
- Fixr: electric water heater installation cost
- Fixr: tankless water heater installation cost
- City of Scottsdale: home improvement permits
- Arizona Registrar of Contractors: when a license is required
Last checked: November 2026.